P - BALING PRESSES
ONE SIZE DOESN'T FIT ALL
From mm 20x20xVar up to 80x80xVar bales, you wil find the right machine for your needs. Our fully customized equipment will always match your requirements.
Plain, grooved, trapezoidal and wavy replaceable liners are isntalled to avoid the possibility to jam the machine. The design is different, according to the material that is processed.
> 80 T/H
Productivity is a key factor in reducing your running cost.
The speed of the machine clearly affects productivity. We will find the right solution for you to guarantee the perfect ratio between required productivity and speed in order to have the lowest cost per ton produced.
With our presses you can be sure you will obtain the desired density, which can be easily set up by the operator from the PLC.
Below are just some examples of density that has been achieved with our baling presses.
Fe: up to 3,6 kg/dm3
Cu: up to 4,5 kg/dm3
Al: up to 1,85 kg/dm3
ENERGY SAVINGS AND EFFICIENCY
The operator panel allows to quickly adjust pressure and cutting lengths depending on the scrap being processed.
Transducers, mounted inside the hydraulic cylinders, monitor the position of each cylinder and allow the operator to adjust the strokes, directly from the PLC. This feature allows to change working cycle to suit the type of scrap that is being processed and also to check the state of wear of internal cyclidner's seals.
LOWEST RUNNING COST
No man operation.
The machine can be installed in line with other equipment and loaded automatically.
If loaded manually, the crane operator will need only to load the machine that will run continuously and automatically.
Tie-bolted box construction, bolted wear plates (with special washboard surface profile allowing to reduce the risk of material jamming the machine), automatic lubrication, advanced automation contribute to maintain a very low maintenance cost.